This page will contain:
- Instructions to install the robot.
- Instructions to install and connect new tools.
- Instructions to install and connect new equipment.
- Instructions to install all software, from scratch.
- Installation of hardware
- Location requirements
- Operating conditions
- Calibration- Required Knowledge
- Skills
- Time
- Link to learning resources
Due: guidelines to install the robot on an appropriate location, and add tools/equipment.
Due: information for configuring the software for a fully assembled and set-up robot.
This content is, at the moment, part of the setup guide: https://docs.openlabautomata.xyz/en/Software&Electronics-Setup
Specific contents are unclear. May complement the hardware installation steps with the corresponding configurations.